RSS | Advanced Search | Site Map | Text Size a- A+
City of Colorado Springs
We Create Community

NOTE - THE NOTED DISAPPROVED ITEMS MAY NOT CONSTITUTE A COMPLETE LIST OF VIOLATIONS. THE DESIGNER IS TO CONDUCT A COMPLETE RE-REVIEW OF THE PLANS FOR ADDITIONAL VIOLATIONS OF THE STANDARD COMMENTS AND INCORRECT INFORMATION PRIOR TO RESUBMITTING.

 System plans must be picked up within 30 days. All system plans left longer than 30 days will be discarded as abandoned.

FIRESTONE AUTOMOTIVE SERVICE CENTER
01358 REPUBLIC DR

Review DateStatusComment(s)
3/17/2020 I2015 IFC - VENT PIPE OUTLETS. Vent pipe outlets for tanks storing Class I, II or IIIA liquids shall be located such that the vapors are released at a safe point outside of buildings and not less than 12 feet (3658 mm) above the finished ground level. Vapors shall be discharged upward or horizontally away from adjacent walls to assist in vapor dispersion. Vent outlets shall be located such that flammable vapors will not be trapped by eaves or other obstructions and shall be not less than 5 feet (1524 mm) from building openings or lot lines of properties that can be built upon. Vent outlets on atmospheric tanks storing Class IIIB liquids are allowed to discharge inside a building where the vent is a normally closed vent. Exception: Vent pipe outlets on tanks storing Class IIIB liquid inside buildings and connected to fuel-burning equipment shall be located such that the vapors are released to a safe location outside of buildings. (2015 IFC ?5704.2.7.3.3) Fixed tanks shall be vented either directly to the outside (used oil storage tanks) or with a "normally closed" cap (stackable oil tanks). The gas caddy's vent cap shall be closed when not in use in filling or emptying.
FYI2015 IFC - EMERGENCY VENTING. Stationary, aboveground tanks shall be equipped with additional venting that will relieve excessive internal pressure caused by exposure to fires. Emergency vents for Class I, II and IIIA liquids shall not discharge inside buildings. The venting shall be installed and maintained in accordance with Section 22.7 of NFPA 30. Exceptions: 1. Tanks larger than 12,000 gallons (45 420 L) in capacity storing Class IIIB liquids that are not within the diked area or the drainage path of Class I or II liquids do not require emergency relief venting. 2. Emergency vents on protected above-ground tanks complying with UL 2085 containing Class II or IIIA liquids are allowed to discharge inside the building. (2015 IFC ?5704.2.7.4)
FYI2015 IFC - LABELING AND SIGNAGE. The fire code official is authorized to require warning signs for the purpose of identifying the hazards of storing or using flammable liquids. Signage for identification and warning such as for the inherent hazard of flammable liquids or smoking shall be provided in accordance with this chapter and Sections 5003.5 and 5003.6. 5703.5.1 STYLE. Warning signs shall be of a durable material. Signs warning of the hazard of flammable liquids shall have white lettering on a red background and shall read: DANGER#FLAMMABLE LIQUIDS. Letters shall be not less than 3 inches (76 mm) in height and 1/2 inch (12.7 mm) in stroke. 5703.5.2 LOCATION. Signs shall be posted in locations as required by the fire code official. Piping containing flammable liquids shall be identified in accordance with ASME A13.1. 5703.5.3 WARNING LABELS. Individual containers, packages and cartons shall be identified, marked, labeled and placarded in accordance with federal regulations and applicable state laws. 5703.5.4 IDENTIFICATION. Color coding or other approved identification means shall be provided on each loading and unloading riser for flammable or combustible liquids to identify the contents of the tank served by the riser. (2015 IFC ?5703.5)
FYI2015 IFC - SMOKING AND OPEN FLAME. Signs shall be posted in storage areas prohibiting open flames and smoking. Signs shall comply with Section 5703.5. (2015 IFC ?5704.2.3.1)
2/21/2020 AttentionEXCEEDS PERMIT QUANTITIES; ANNUAL HAZARDOUS MATERIALS OPERATIONAL PERMIT REQUIRED. COLLECT REQUIRED INFORMATION FOR ANNUAL PERMITTING. Flammable liquids > 5 gal Repair garage
AttentionHAMMERS: The information from this permit application must be entered into the HAMMERS program and added to the facilities hazardous materials information. Visit the following link: https://hammers.springsgov.com/ to add the information to the facility.
AttentionINSPECTION REQUIRED. An inspection of this hazardous materials installation/process is required prior to final Certificate of Occupancy/occupancy of the building/commencement of hazardous materials operations. To schedule the hazardous materials inspection, please call 719-385-5978 and follow prompts to schedule the inspection. Please have the plan review number ready before calling.
DisapprovedPlease provide specifications on the "gas caddy (25 gal) (#19)". If this is supposed to be filled with gasoline, that did not appears in the HMIS. Update the HMIS as necessary and provide fill, use, and venting specifications.
FYICONTROL AREAS, AS SHOWN ON THIS SUBMITTAL ARE AS FOLLOWS
FYICHEMICAL INVENTORY, AS DECLARED Various flammable liquids (IB/IC) - 6.3 gal Bead sealers and windshield fluid/deicer Combustible liquids (II/IIIA/IIIB) - 954 gal Oils/coolants/brake fluid/grease/lubes - see HMIS Aerosols Class 3 - 167lbs various - see HMIS
DisapprovedPlease provide specifications on the "used oil tank/bench (#15)" How emptied from the supplier? How is it vented? Is it vented to the outside or are equipped with a "normally closed vacumm/pressure operated valve"? What is its construction design?
DisapprovedPlease provide specifications on the "Stackable 2 tank oil system (#49)" How are they filled from the supplier? How are they vented? Are they vented to the outside or are equipped with a "normally closed vacumm/pressure operated valve"? What is their construction design?


 

Contact Us: Email Us - Call: 385-CITY (719-385-2489) - RSS - Privacy, Linking and ADA Policies - designed, developed by projecta.com

printer friendly version Printer friendly version